ABB DCS 500B

DCS500 Pin and Parameter list
A 97
FEXC2_COM_ERRORS
Signal of MAINTENANCE function.
Number of transmission errors in FEXC-communication link for field exciter no. 2.
11215 S: I2 SC: - HL: - LL: - D: - U: -
CMT_COM_ERRORS
Signal of MAINTENANCE function.
Number of transmission errors in DDCTool communication link.
11216 S: I2 SC: - HL: - LL: - D: - U: -
CDI300_BAD_CHAR
Signal of MAINTENANCE function.
Number of transmission errors in panel communication link.
11217 S: I2 SC: - HL: - LL: - D: - U: -
CNT_SW_VERSION
Signal of MAINTENANCE function.
DCS 500 converter firmware revision.
11218 S: I2 SC: - HL: - LL: - D: - U: -
CNT_BOOT_SW_VERSION
Signal of MAINTENANCE function.
DCS 500 converter boot firmware revision.
11219 S: I2 SC: - HL: - LL: - D: - U: -
FEXC1_SW_VERSION
Signal of MAINTENANCE function.
Field exciter no. 1 firmware revision.
11220 S: I2 SC: - HL: - LL: - D: - U: -
FEXC2_SW_VERSION
Signal of MAINTENANCE function.
Field exciter no. 2 firmware revision.
11221 S: I2 SC: - HL: - LL: - D: - U: -
PROGRAM_LOAD
Signal of MAINTENANCE function.
Calculated load of DCS 500 control program.
Calculation is started by setting DRIVE_MODE, 1201 = PROGRAM_LOAD.
The calculation will take about 20 seconds.
11222 S: I2 SC: - HL: - LL: - D: - U: %