ABB DCS 500B

DCS500 Pin and Parameter list
A 119
1
12-Pulse Operating, 63, 115
A
ACC_COMP.MODE (P17-18), 47
ACC_COMP.TRMIN (P17-19), 47
ACCEL1 (P17-08), 46
ACCEL2 (P17-11), 46
ACCELCOMP:OUT (S117-02), 102
ACK_CONV_FAN (P9-10), 27
ACK_MAIN_CONT (P9-12), 28
ACK_MOTOR_FAN (P9-11), 28
ACT_BRAKE (P3-04), 14
ACTUAL VALUE 1 (P12-10), 37
ACTUAL VALUE 2 (P12-11), 37
ADJ_REF1 (P36-15), 65
AI1:ERR (S101-06), 74
AI1:OUT- (S101-05), 74
AI1:OUT+ (S101-04), 74
AI1_CONV_MODE (P1-04), 8
AI1_HIGH_VALUE (P1-05), 8
AI1_LOW_VALUE (P1-06), 8
AI2:ERR (S101-09), 75
AI2:OUT- (S101-08), 74
AI2:OUT+ (S101-07), 74
AI2_CONV_MODE (P1-07), 9
AI2_HIGH_VALUE (P1-08), 9
AI2_LOW_VALUE (P1-09), 9
AI3:ERR (S101-12), 75
AI3:OUT- (S101-11), 75
AI3:OUT+ (S101-10), 75
AI3_CONV_MODE (P1-10), 9
AI3_HIGH_VALUE (P1-11), 9
AI3_LOW_VALUE (P1-12), 9
AI4:ERR (S101-15), 76
AI4:OUT- (S101-14), 75
AI4:OUT+ (S101-13), 75
AI4_CONV_MODE (P1-13), 10
AI4_HIGH_VALUE (P1-14), 10
AI4_LOW_VALUE (P1-15), 10
AI5:ERR (S101-18), 76
AI5:OUT- (S101-17), 76
AI5:OUT+ (S101-16), 76
AI5_CONV_MODE (P1-16), 10
AI5_HIGH_VALUE (P1-17, 10
AI5_LOW_VALUE (P1-18), 10
AI6:ERR (S101-21), 76
AI6:OUT- (S101-20), 76
AI6:OUT+ (S101-19), 76
AI6_CONV_MODE (P1-19), 10
AI6_HIGH_VALUE (P1-20), 10
AI6_LOW_VALUE (P1-21), 11
AITAC:ERR (S101-03), 74
AITAC:OUT- (S101-02), 74
AITAC:OUT+ (S101-01), 74
AITAC_CONV_MODE (P1-01), 8
AITAC_HIGH_VALUE (P1-02), 8
AITAC_LOW_VALUE (P1-03), 8
ALARM (S109-05), 86
ALARM_WORD_1 (S111-04), 90
ALARM_WORD_2 (S111-05), 91
ALARM_WORD_3 (S111-06), 91
Alarms, 33, 89
Analog Inputs, 8, 74
Analog Outputs, 12
AO1.[IN] (P2-01), 12
AO1_NOMINAL_V (P2-02), 12
AO1_NOMINAL_VAL (P2-04), 12
AO1_OFFSET_V (P2-03), 12
AO2.[IN] (P2-05), 12
AO2_NOMINAL_V (P2-06), 12
AO2_NOMINAL_VAL (P2-08), 12
AO2_OFFSET_V (P2-07), 12
Arm.CURR.Both (S136-04), 115
Arm.Curr.Slave (S136-02), 115
ARM_ALPHA (S104-01), 79
ARM_ALPHA_LIM_MAX (P4-12), 16
ARM_ALPHA_LIM_MIN (P4-13), 16
ARM_CONT_CURR_LIM (P4-09), 15
ARM_CURR_ACT (S105-02), 80
ARM_CURR_CLAMP (P4-17), 16
ARM_CURR_LIM_N (P23-08), 57
ARM_CURR_LIM_N (P4-16), 16
ARM_CURR_LIM_P (P23-07), 57
ARM_CURR_LIM_P (P4-15), 16
ARM_CURR_PI_KP (P4-07), 15
ARM_CURR_PI_KP (P4-08), 15
ARM_CURR_REF (S104-05), 79
ARM_CURR_REF_SLOPE (P4-06),
15
ARM_DIR (S104-02), 79
ARM_L (P4-10), 16
ARM_OVERCURR_LEV (P5-12), 19
ARM_OVERVOLT_LEV (P5-11), 19
ARM_R (P4-11), 16
AUTO-RECLOSING (S109-14), 87
B
BACKUPSTOREMODE (S112-02), 94
BC (S112-05), 95
BC not Zero (S136-21), 117
BC-Logic (P36-16), 66
BLOCK (P4-04), 15
BR_RELEASE (P3-02), 14
Brake Control, 14, 78
BRAKE_RUN (S103-05), 78
Bridge (S136-11), 116
Bridge of Slave (S136-12), 116
Bridge_logic (P36-09), 64
BRIDGE_TEMP (S105-07), 80
C
CMT_COM_ERRORS (S112-16), 97
CMT_DCS500_ADDR (P12-02), 36
CNT_BOOT_SW_VERSION (S112-
19), 97
CNT_SW_VERSION (S112-18), 97
COAST_STOP (P9-05), 27
COMFAULT_MODE (P9-20), 29
COMFAULT_TIMEOUT (P9-21), 29
COMM_FAULT (S109-15), 87
COMMIS_STAT (S112-01), 93
CONST_REF.[ACT1] (P19-01), 49
CONST_REF.[ACT2] (P19-02), 49
CONST_REF.[ACT3] (P19-03), 49
CONST_REF.[ACT4] (P19-04), 49
CONST_REF.DEF (P19-05), 49
CONST_REF.REF1 (P19-06), 49
CONST_REF.REF2 (P19-07), 49
CONST_REF.REF3 (P19-08), 49
CONST_REF.REF4 (P19-09, 49
CONST_REF:ACT (S119-02), 104
CONST_REF:OUT (S119-01), 104
CONSTANT_0 (S125-01), 110
CONSTANT_-1 (S125-02), 110
CONSTANT_1 (S125-03), 110
CONSTANT_10 (S125-05), 110
CONSTANT_100 (S125-06), 110
CONSTANT_1000 (S125-07), 110
CONSTANT_2 (S125-04), 110
CONSTANT_31416 (S125-08), 110
Constants, 110
Conv.Curr.Both (S136-03), 115
Conv.Curr.Slave (S136-01), 115
CONV_CURR_ACT (S105-01), 80
CONV_TEMP_DELAY (P5-27), 22
CONV_TYPE (S105-13), 81
Converter, 18, 80
CUR,FLX,VLT_100% (S125-12), 111
CUR,FLX,VLT_-100% (S125-13), 111
CUR_RIPPLE_LIM (P4-21), 17
CUR_RIPPLE_MONIT (P4-20), 17
Curr.-Ref.1 (S136-05), 115
Curr.-Ref.2 (S136-08), 116
CURR_ACT_FILT_TC (P5-23), 21
CURR_DER_IN_LIM (S104-04), 79
CURR_LIM_N (S123-08), 108
CURR_LIM_P (S123-07), 108
CURR_REF (P4-02), 15
CURR_REF_IN_LIM (S104-03), 79
CURR_STEP] (P4-03), 15
CURRENT CONTROL, 15, 79
CURRENT_RISE_MAX (P4-18), 16
D
Data Logger, 23, 82
DATASET1.[OUT1] (S101-22), 76
DATASET1.[OUT2] (S101-23), 77
DATASET1.[OUT3] (S101-24), 77
DATASET2.[IN1] (P2-09), 12
DATASET2.[IN2] (P2-10), 12
DATASET2.[IN3] (P2-11), 12
DATASET3.[OUT1] (S101-25), 77
DATASET3.[OUT2] (S101-26), 77
DATASET3.[OUT3] (S101-27), 77
DATASET4.[IN1(P2-12), 13
DATASET4.[IN2] (P2-13), 13
DATASET4.[IN3] (P2-14), 13