Chapter 1 - Introduction
DCS 600 Operating Instructions
IV F
1 - 1
How to use this manual
The purpose of these operating instructions is to provide detailed
information on how to start up a thyristor power converter from the
DCS 600 series.
Note: If it is not mentioned explicitly all details given in
these Operating Instructions will be valid for series
DCS 600!
Contents of this manual
Chapter 1 - Introduction
It describes how to use this manual and the boundary conditions
applying.
Chapter 2 - Start-Up Instructions
We recommend working your way through the Start-Up Instructions
step by step, since in this way you will get to perform all important
parameter setting routines.
Chapter 3 - How to Handle the Control and Display Panel
This chapter describes how to operate the CDP 312 control and
display panel.
Chapter 4 - Signals and Troubleshooting
This chapter describes the available signals and possibilities of dis-
play with DCS 600. As far as fault signals are concerned there will
be indicated measures (actions) to be taken for troubleshooting.
Target group
This manual is designed to help those responsible for planning, in-
stalling, starting up and servicing the thyristor power converter.
These people should possess
• basic knowledge of physics and electrical engineering, electrical
wiring principles, components and symbols used in electrical en-
gineering, and
• basic experience with DC drives and products.
Associated
publications
The DCS 600 documentation includes the following:
System Descriptions DCS 600
Technical Data DCS Thyristor Power Converters
Software Description DCS 600
Service Manual
12-Pulse Manual
Installation Manual
DCS 600 - 'HVFULSWLRQRIWKHGULYHVSHFLILFVHULDOOLQNLQWHUFRQQHF
WLRQV
These Operating Instructions
To Next Page
Loading...
Need help?
General
