ABB DCS 600 MultiDrive - Chapter 1 - Introduction; How to use this manual

Contents
iv DCS 600 Operating Instructions
IV F OPERATING INSTRUCTIONS
Safety Instructions
Chapter 1-Introduction
How to use this manual.................................................................................................
IV F 1-1
Contents of this manual ................................................................................................
IV F 1-1
Target group .................................................................................................................
IV F 1-1
Associated publications ...............................................................................................
IV F 1-1
Incoming inspection ......................................................................................................
IV F 1-2
Storage and transport ...................................................................................................
IV F 1-2
Rating plate ..................................................................................................................
IV F 1-2
Chapter 2-Start-Up Instructions
General notes ...............................................................................................................
IV F 2-1
2.1 Preparatory work ....................................................................................................
IV F 2-7
2.2 Scaling intra-unit signals ........................................................................................
IV F 2-8
2.3 Presetting the field supply unit ..............................................................................
IV F 2-10
2.4 Adjusting the current controller..............................................................................
IV F 2-13
2.5 Speed feedback balancing....................................................................................
IV F 2-15
2.6 Balancing the field supply unit and the EMF controller ..........................................
IV F 2-18
2.7 Balancing the speed controller, plus fine-balancing the EMF ................................
IV F 2-22
2.8 Matching the thyristor power converter unit to the system conditions concerned ..
IV F 2-23
2.9 Manual balancing of the controllers.......................................................................
IV F 2-23
2.10 Start-Up of the serial communication ..................................................................
IV F 2-24
DCS 600 and APC ..........................................................................................
IV F 2-24
DCS 600 and AC 70 (PM 810) ........................................................................
IV F 2-25
DCS 600 and AC 80 Module bus.....................................................................
IV F 2-26
DCS 600 and AC 80 Drive bus ........................................................................
IV F 2-27
DCS 600 and FCI (CI 810) / AC 400................................................................
IV F 2-28
DCS 600 and Profibus.....................................................................................
IV F 2-29
DCS 600 and Modbus PLUS...........................................................................
IV F 2-31
DCS 600 and CS 31........................................................................................
IV F 2-33
DCS 600 and DCF 600 by FEXlink..................................................................
IV F 2-34
Chapter 3 - Handling of Control Panel CDP 312
3.1 Overview.................................................................................................................
IV F 3-1
Panel Link .........................................................................................................
IV F 3-1
Mounting the Panel ..........................................................................................
IV F 3-1
Languages for Panel Display.............................................................................
IV F 3-1
3.2 Start Mode ..............................................................................................................
IV F 3-2
3.3 Panel Functions ......................................................................................................
IV F 3-3
Actual Signal Display Mode...............................................................................
IV F 3-3
Parameter Mode................................................................................................
IV F 3-4
Function Mode...................................................................................................
IV F 3-4
Drive Mode........................................................................................................
IV F 3-5
Reference Input.................................................................................................
IV F 3-5