ABB DCS 600 MultiDrive - Page 9

Contents
DCS 600 Operating Instructions v
3.4 Parameter Selecting and Changing of Value...........................................................
IV F 3-6
3.5 Saving of the Parameters to backup memory..........................................................
IV F 3-8
3.6 FAULT resetting (RESET).......................................................................................
IV F 3-9
3.7 EMERGENCY STOP resetting (RESET).................................................................
IV F 3-9
3.8 Fault History Display .............................................................................................
IV F 3-10
3.9 Uploading and Downloading of Parameters (UPLOAD/DOWNLOAD)...................
IV F 3-11
3.10 Setting of the Display Contrast............................................................................
IV F 3-14
3.11 Full Name of Actual Signals ................................................................................
IV F 3-14
3.12 Selection of Actual Signals Group 1 ... 9 .............................................................
IV F 3-15
3.13 Drive Mode .........................................................................................................
IV F 3-16
3.14 Running the Drive ...............................................................................................
IV F 3-17
Operational Command Keys............................................................................
IV F 3-17
Running the DC- Drive from the CDP 312 ......................................................
IV F 3-17
3.15 Speed Reference Setting for the Drive................................................................
IV F 3-18
Chapter 4 - Signals and Troubleshooting
4.1 Display of status, alarm and fault signals ................................................................
IV F 4-1
Categories of signals and possibilities of display ...............................................
IV F 4-1
4.2 General messages..................................................................................................
IV F 4-2
From SDCS-CON-2 board.................................................................................
IV F 4-2
From SDCS-AMC-DC board..............................................................................
IV F 4-2
4.3 Starting errors (E) [from SDCS-CON-2 board] ........................................................
IV F 4-2
4.4 Fault Signals (F)......................................................................................................
IV F 4-3
Fault Signals referring to the SDCS-AMC-DC board........................................
IV F 4-10
4.5 Alarm Signals (A)..................................................................................................
IV F 4-12
Alarm Signals referring to the SDCS-AMC-DC board ......................................
IV F 4-14