Chapter 3 - Handling of Control Panel CDP 312
DCS 600 Operating Instructions
IV F
3 - 7
Table (continued): Parameter Selecting and Changing of Value
Step Function Press key Display after key is
pressed
3. To select an Index.
While pressing the key down,
only the Index number and
name is displayed. When the
key is released the value of the
Index is also displayed.
6\ZW
=>+<>=>9:
/7/=>9:79./
6\ZW
=>+<>=>9:
/7/=>9:79./
<+7:=>9:
4. To select the Parameter value
(for changing).
ENTER
6\ZW
=>+<>=>9:
/7/=>9:79./
E<+7:=>9:G
5a. To change the Parameter
value by scrolling:
(slow change)
(fast change)
6\ZW
=>+<>=>9:
/7/=>9:79./
E>9<;?/6373>G
5b. To change the Pointer connec-
tion by scrolling at first:
(Group number) --->
then: (Index number) --->
of the target.
6\ZW
#-98-977?83-+>3
38.B+->W]
E!G
6a. To confirm / send the new value
to the drive (to finish the
changing procedure).
ENTER
6\ZW
=>+<>=>9:
/7/=>9:79./
>9<;?/6373>
6b. To cancel the new setting and
keep the original value press
any of the four keys
.
The selected Keypad Mode is
entered.
ACT
PAR
FUNC
DRIVE
6\ZW
=>+<>=>9:
/7/=>9:79./
<+7:=>9:
To Next Page
Loading...
