77
Exchange of SDCS-CON-4
3ADW000195R0501 DCS800 Service Manual e e
Click Save:
2. Write down type code of the drive
Write down the contents of TypeCode (97.01). This information must be manually
set in the new SDCS-CON-4.
3. Set jumpers on the new SDCS-CON-4 according to the old SDCS-CON-4
Copy the jumper settings (S1 to S4) of the old SDCS-CON-4 onto the new SDCS-
CON-4 accordingly.
4. Exchange the SDCS-CON-4
Remove the
old SDCS-
CON-4
1. Remove the DCS Control Panel and design cover:
Remove design cover
2. Remove all plug in options on the intermediate cover e.g.:
serial communication modules (R-type),
Remove DCS Control Panel
Depress the locks by means of a
screwdriver to remove the design
cover
To Next Page
Loading...
