ABB DPA UPScale ST40 - Commands; Main Menu; Metering; Measurements

Modifications reserved
Page 45/79
6.2.2 Main menu
DESCRIPTION LCD-DISPLAY
1
Logging control. A log of the last 64 events is
stored in the power management display.
 EVENT LOG
MEASUREMENTS
2
In the Measurements menu: monitor voltages,
power, frequencies, currents, autonomy, etc.
 MEASUREMENTS
COMMANDS
3
The Command menu lets the user perform the
commands: load to the inverter, load to bypass,
battery test.
 COMMANDS
UPS DATA
4
The UPS Data are the UPS personalized
information “serial number.”
 UPS DATA
SET-UP USER
5
Various settings can be made by the user:
date/time, automatic battery test, etc.
 SET-UP USER
SET-UP SERVICE
6
Various adjustments can be performed by the
service staff.
 SET-UP SERVICE
NO MORE MENU
6.2.3 Commands
DESCRIPTION LCD-DISPLAY
1
Transfer load to inverter
 LOAD TO INVERTER
LOAD TO BYPASS
2
Transfer load to bypass.
 LOAD TO BYPASS
PERFORM BATT.TEST
3
Battery test
 PERFORM BATT.TEST
NO MORE COMMANDS
6.3 Metering
6.3.1 Measurements
DESCRIPTION LCD-DISPLAY
1
Battery Runtime
BATT. RUN TIME (MIN)
00h 00m
2
UPS-output frequency
OUTPUT FREQUENCY (HZ)
50.00
3
Bypass frequency.
BYPASS FREQUENCY (HZ)
50.00
4
Battery voltage
BATTERY VOLTAGE (V)
+ 0.0 - 0.0
5
Battery charger current
BATT. CHARGE CUR. (A)
+ 0.0 - 0.0