Operating the Gas Analyzer 59
Start the communication between the gas analyzer and the computer
Communication between the configurator and the gas analyzer is started
in the menu "Options – Communication Properties…" or by clicking the
symbol
. Input either the IP address or the network name (server
name) of the gas analyzer (see the following example of a point-to-point
connection).
Receiving Configuration Data
After communication has been started, the configuration data can be
received from the gas analyzer.
Menu "File – Receive Data" or
.
Sending Configuration Data
After the configuration data been has edited, it can be sent to the gas
analyzer. The configuration mode is active after an automatic cold restart
of the gas analyzer.
Menu "File – Send Data" or
.
Saving Configuration Data
The configuration data of the gas analyzer can be stored in the computer.
The stored configuration file can be edited at a later date and sent to the
gas analyzer.
Menu "File – Save As..." or
.
To Next Page
Loading...
Need help?
General
