EL3000 CONTINUOUS GAS ANALYZERS | CI/EL3000-EN REV. B 11
Version with type of protection II 3G for measurement of
non-flammable gases and vapors
NOTE
The version for the measurement of flammable gases and vapors and the
explosion-proof version with degree of protection II 3G (see page 11) are
different versions of the gas analyzer and designed for different applica-
tions.
Description
The gas analyzer model EL3040 in degree of protection II 3G has been tested
for explosion protection and is suitable for use in hazardous areas in com-
pliance with the technical data (see page 16) and the special conditions (see
below).
The gas analyzer may be used for the measurement of non-flammable gases
and vapors.
The gas analyzer is only intended for installation indoors.
The analyzers Uras26, Magnos206, Magnos28 and Caldos27 can be installed
individually or as combinations of Uras26 with Magnos206 or Magnos28 or
Caldos27 or oxygen sensor in the gas analyzer.
Operating the instrument under regular conditions cannot cause any ignita-
ble sparks, arcs or impermissible temperatures inside the instrument.
Explosion-proof with: Spark-free instruments and devices with low power
consumption; sealed or enclosed instruments.
The gas analyzer is designated pursuant to European Directive 2014/34/EU
with:
II 3G Ex nA nC IIC T4 Gc
Type examination certificate no. BVS 16 ATEX E 085 X.
Parameters
Electrical data
Power supply AC 100 to 240 V
Power consumption max. 187 VA
Pneumatic data
Purge gas
Inlet pressure max. 1104 hPa
Sample gas
Non-flammable sample gas
Inlet pressure max. 1100 hPa
Flow rate (gas outlet atmospheric) max. 100 l/h
Ambient temperature +5 to +45 °C
To Next Page
Loading...
