F, V, W S e r i e s
Electromagnetic flowmeters | Full-bore flow sensors 1 Safety
2 OI/FEF/FEV/FEW–EN Rev. D
1 Safety
Information in this manual is intended only to assist our customers in the efficient operation of our
equipment. Use of this manual for any other purpose is specifically prohibited and its contents are not to be
reproduced in full or part without prior approval of the Technical Publications Department.
1.1 Electrical Safety
This equipment complies with the requirements of CEI/IEC 61010-1:2001-2 'Safety Requirements for
Electrical Equipment for Measurement, Control and Laboratory Use' and complies with NIST and OSHA.
If the equipment is used in a manner NOT specified by the Company, the protection provided by the
equipment may be impaired.
1.2 Symbols
One or more of the following symbols may appear on the equipment labelling:
Warning – Refer to the manual for
instructions
Direct current supply only
Caution – Risk of electric shock Alternating current supply only
Protective earth (ground) terminal Both direct and alternating current supply
Earth (ground) terminal
The equipment is protected
through double insulation
To Next Page
Loading...
Need help?
General
