72
000442CG-F
7 - Operation
The sequence of screens displayed is shown below, with a description of the parameters monitored.
EXXX
Lun 22 Lug 15:55
Inverter OK
Lun 22 Lug 15:55
Type OUTD
P/N -3xxx-
S/N XXXXXX
FW rel. XXXX
E-day 0.0kWh
$-day 0.0EUR
E-tot 0kWh
E-par 0kwh
Pout 330W
COSp 1.000
>No regolazione
Tboost 29.5`C
Tinv 26.6`C
DOWN UP
DOWN UP
DOWN UP
DOWN UP
DOWN UP
DOWN UP
Ppk 0W
PpkDay 0W
DOWN UP
DOWN UP
VoutR 230V
Vout Avg 230V
VoutS 230V
Vout Avg 230V
VoutT 230V
Vout Avg 230V
Vout ST 380V
Vout TR 380V
IoutR 0.0A
FoutR 50.0Hz
IoutS 0.0A
FoutS 50.0Hz
DOWN UP
DOWN UP
DOWN UP
DOWN UP
DOWN UP
Vout RS 380V
DOWN UP
DOWN UP
IoutT 0.0A
FoutT 50.0Hz
DOWN UP
Vin1 0V
Iin1 0.0A
Vin2 0V
Iin2 0.0A
Pin1 0W
Pin2 0W
DOWN UP
DOWN UP
DOWN UP
Riso 20.0Mo
Ileak 0mA
DOWN UPDOWN UP
DOWN UPDOWN UP
Vbulk 0V
Vbulk_m 0V
DOWN UP
Vin 0V
Iin 0.0A
Pin 0W
DOWN UP
DOWN UP
Inverter status. The code for any malfunction will be displayed.
Date and time as set on the inverter
Errors/Warnings
On
Independent
inputs
No
Errors/Warnings
Parallel
inputs
Type: Outdoor inverter type (OUTD)
P/N: FIMER product identication code
S/N: Sequential serial number
FW rel. : Firmware version installed
E-day: Energy produced today
$-day: Today's savings/earnings
E-tot: Energy produced since the inverter was commissioned
E-par: Partial Energy produced
Pout: Instantaneous output power
Phase difference set for feeding in reactive power
Reactive power regulation mode currently set
Tboost: Internal temperature in the booster circuit (DC/DC)
Tinv: Internal temperature in the inverter circuit (DC/AC)
Ppk: Maximum output power peak since the inverter was commissioned
PpkDay: Maximum daily output power peak
VoutR: Output voltage (R phase)
Vout Avg: Average R-phase output voltage
VoutS: Output power (S phase)
Vout Avg: Average S-phase output voltage
VoutT: Output voltage (T phase)
Vout Avg: Average T-phase output voltage
Vout RS: Phase-to-phase output voltage between R and S phases
Vout ST: Phase-to-phase output voltage between S and T phases
Vout TR: Phase-to-phase output voltage between T and R phases
IoutR: Output current (R phase)
FoutR: Output frequency (R phase)
IoutS: Output current (S phase)
FoutS: Output frequency (S phase)
IoutT: Output current (T phase)
FoutT: Output frequency (T phase)
Riso: Insulation resistance on DC input side (PV generator)
Ileak: Leakage current on DC input side (PV generator)
Vin 1: Input voltage channel 1 Vin: Input voltage
Iin 1: Input current channel 1 Iin: Input current
Vin 2: Input voltage channel 2
Iin 2: Input current channel 2
Pin1: Instantaneous input power channel 1
Pin: Instantaneous input power
Pin2: Instantaneous input power channel 2
Vbulk: Internal voltage at the bulk capacitor terminals (booster circuit)
Vbulk_m: Internal voltage at the bulk capacitor mid-point (booster circuit)
To Next Page
Loading...
