• ACS880 primary control program version 2.10 or later. For the
compatibility of other control programs, contact your local ABB
representative.
Target audience
The manual is intended for people who install, start-up, use and
service the ATEX-certified thermistor protection module of the drive.
Read the manual before working on the drive. You are expected to
know the fundamentals of electricity, wiring, electrical components,
electrical schematic symbols and ATEX/Ex regulations.
Exclusion of liability
ABB is not responsible for the implementation, verification and
validation of the overall safety system. It is the responsibility of the
system integrator (or other party) who is responsible for the overall
system and system safety.
The system integrator (or other responsible party) must make sure
that the entire implementation complies with the instructions in this
manual, all relevant standards, directives and local electrical code,
and that the system is tested, verified and validated correctly.
Related manuals
CodeName
Drive hardware
3AUA0000078093ACS880-01 hardware manual
3AUA0000138495ACS880-04 drive module packages hardware manual
3AXD50000045932ACS880-11 hardware manual
3AXD50000045933ACS880-31 hardware manual
3AXD50000022021ACS880-14 and -34 single drive module packages
hardware manual
3AXD50000034664ACS880-04F drive modules hardware manual
3AUA0000105718ACS880-07 drives (45 to 710 kW) hardware manual
16 Introduction to the manual
To Next Page
Loading...
