USER INTERFACE
The System view shows all blocks connected in hard parallel configuration and their mode of operation
as illustrated in Figure 7.12.
Figure 7.12: MV UPS system view page
A “Reset” button is available on the bottom right side of the screen below the Start/Stop button.
When activated, this button will rest a single block or all UPSs simultaneously. The function is available
on all GDMs which are part of the same UPS system.
Once the ‘Reset’ button is pressed, the GDM will show a Reset confirmation window with the message
“Please Select: RESET this single BLOCK or RESET the entire SYSTEM” as illustrated in Figure 7.13.
The User can confirm the Reset operation by selecting ‘RESET’, ‘RESET system’ or can select cancel to
dismiss the operation. Figure 7.14 and Figure 7.15 show the RESET confirm dialogue boxes for entire
system and block reset respectively.
Figure 7.13: GDM- RESET confirmation Dialogue box
To Next Page
Loading...
