ABB HT595584 - Table 6: Foot Screws, Number of Cup Springs

Operation Manual / 4 Product description / A100-M axial
2 Removal and installation / 2.3 Installing the turbocharger
© Copyright 2019 ABB. All rights reserved. HZTL4033_EN Rev.D December 2019
Product Number of cup springs X
A175-M 11
Table6: Foot screws, number of cup springs
Holes b1/b2 are needed to achieve the required clamping length. An additional drill hole is
not needed at the higher turbine-end foot side (01).
Page 15 / 114