ABB HT604133 - Page 123

Operation Manual / 4 Product description / A130-H.. - A140-H
Tables
© Copyright 2020 ABB. All rights reserved. HZTL4030_EN Revision F February 2020
Tables
Table1: Related documents .......................................... 3
Table2: Weight of complete turbocharger unit....... 8
Table3: Requirements for threaded rods ................ 14
Table4: Tightening torque for standard nuts......... 16
Table5: Torque-controlled tightening of the pres-
sure screws .................................................................... 18
Table6: Lubricating oil pressure at oil inlet before
turbocharger ................................................................. 25
Table7: Lubricating oil temperature at the inlet ... 26
Table8: Lubricating oil temperature at the outlet 26
Table9: Tightening torque(86505).......................... 30
Table10: Expected replacement intervals .............. 38
Table11: Maintenance table ....................................... 40
Table12: Value table for soaking............................... 48
Table13: Malfunctions when starting – Delayed
start-up ........................................................................... 51
Table14: Malfunctions when starting – Vibrations 51
Table15: Malfunctions when starting – Rubbing of
rotating parts................................................................. 51
Table16: Malfunctions during operation – Lubricat-
ing oil pressure too low............................................... 52
Table17: Malfunctions during operation – Speed re-
duces............................................................................... 52
Table18: Malfunctions during operation – Speed in-
creases ........................................................................... 52
Table19: Malfunctions during operation – Exhaust
gas temperature too high .......................................... 53
Table20: Malfunctions during operation – Charge
air pressure too low..................................................... 53
Table21: Malfunctions during operation – Charge air
pressure too high ......................................................... 54
Table22: Malfunctions during operation – Engine
performance losses ..................................................... 54
Table23: Malfunction – Turbocharger pumping.... 55
Table24: Malfunction – Sporadic surge blows....... 55
Table25: Malfunctions when stopping – Runout
noises.............................................................................. 56
Table26: Malfunctions when stopping – Runout
time too short............................................................... 56
Table27: Malfunction of the speed measurement
system – No signal or poor signal amplitude .......... 57
Table28: Malfunction of the speed measurement
system – Measured speed too high ........................... 57
Table29: Malfunction of the speed measurement
system – Measured speed too low............................. 57
Table30: Swivel lifting eyes......................................... 60
Table31: Weights of assemblies................................. 61
Table32: 3 press-off screws........................................ 64
Table33: 6 press-off screws........................................ 65
Table34: Permissible clearances A and B ................. 73
Table35: Nozzle ring compression PD ...................... 74
Table36: End position of the nozzle ring, control di-
mension H ....................................................................... 76
Table37: Tightening torque (51007).......................... 77
Table38: Tightening torque (79041) ......................... 78
Table39: Tightening torque (72011) ......................... 79
Table40: Permissible clearances N and R ................ 80
Table41: Tightening torque (72020).......................... 81
Table42: Tightening torque (51009) ......................... 82
Table43: Tightening torques of the screw fittings.....
83
Table44: Customer spare part set 97070 ................ 89
Table45: Spare parts list ............................................. 91
Page 93 / 93Page 93 / 93