Operation Manual / A130-H.. - A140-H..
2 Safety / 2.13 Safe operation
© Copyright 2021 ABB. All rights reserved. HZTL4030_EN Rev.G July 2021
2.13 Safe operation
Mechanical hazards during operation
During standard operation, no mechanical hazards are caused by the turbocharger itself if it
has been properly installed.
Safety during commissioning and operation
u Visually inspect your working environment before starting work.
u Remove any obstacles and objects littering the workplace.
u Check all pipes to and from the turbocharger for damage and leaks before commission-
ing.
u Check turbocharger for recognisable damage or defects every 12 hours of operation or at
least once a day.
u Report any damage and any alterations of operational characteristics to the responsible
department immediately.
u In case of damage, take the turbocharger out of operation immediately and safeguard
against accidental/unauthorised use.
u When switching on operating energy supplies (hydraulics, pneumatics, electricity), pay at-
tention to the risks that may occur as a consequence of this energy input.
WARNING
Missing burst protection
Operating the turbocharger without burst protection can result in serious
injury or fatal accidents.
u Only operate the turbocharger with burst protection from ABB fitted.
Page 23 / 122
To Next Page
Loading...
Need help?
General
