Operation Manual / TPS44-H.. - TPS52-H..
6 Operation and service / 6.3 Expected replacement intervals
© Copyright 2021 ABB. All rights reserved. HZTL4037_EN Rev.F May 2021
Component Operating hours [h]
(GAS / MDO)
Number of engine start cycles
(Peak shaving mode)
Turbine casing 25000…50000 5000…10000
Nozzle ring 25000…50000 5000…10000
Heat sheet metal 25000…50000 5000…10000
Rotating components See rating plate information
1)
20000
Bearing parts 12000…24000 5000
Other casings 50000 - -
Table12: Expected replacement intervals
GAS = Gas
MDO = Marine Diesel Oil
1)
The recommended replacement intervals of the compressor and turbine wheels are spe-
cified with the aid of the safety concept for rotating parts (SIKO) and dependent on the
operating conditions.
Influencing parameters
The specified values are guideline values and are not guaranteed. The actual values can devi-
ate significantly from the guideline values, for example, due to the following influences:
¡ Fuel quality and fuel treatment
¡ Load profile (thermal cycling, also number of starts/stops, emergency shutdowns, oper-
ating point)
¡ Gas inlet temperature
¡ Turbocharger specification
¡ System-specific operating conditions (combustion quality, exhaust gas composition)
For bearing parts
¡ Lubricating oil quality (oil filtering, oil condition, oil monitoring)
¡ Load profile (speed, pressure conditions, temperature)
¡ Number of starts/stops
¡ Unbalance of the rotor (degree of contamination).
Page 51 / 111
To Next Page
Loading...
Need help?
General
