Operation Manual / TPS44-H.. - TPS52-H..
8 Periodic maintenance work / 8.2 Cleaning components mechanically
© Copyright 2021 ABB. All rights reserved. HZTL4037_EN Rev.F May 2021
8.2.3 Compressor-end, non-rotating parts
WARNING
Handling operating materials and supplies
Swallowing or inhaling vapours of operating materials and supplies or con-
tact with them may be harmful to health.
u Do not breathe in these substances and avoid contact with the skin.
u Ensure proper ventilation.
u Observe the information in the material safety data sheet for the operat-
ing materials and supplies.
u Wear personal protective equipment (PPE) according to the material
safety data sheet.
u Comply with local legislation.
Wear safety goggles.
Wear safety gloves to protect against chemical hazards.
Wear a respiratory mask to protect against gases.
The following parts, which are relevant in terms of performance, can be cleaned in accord-
ance with the description below.
Fig.20: Cleaning the compressor casing, diffuser mechanically
72000 Compressor casing
79000 Diffuser
u Steam-clean the above-mentioned components or soak in diesel oil or water with house-
hold cleaning agents. After soaking, remove contamination with a brush.
u Dry components completely.
u Spray cleaned surfaces with penetrating oil. Do not spray exterior surfaces of the tur-
bocharger.
u Dispose of contaminated water and cleaning agents in accordance with the information
in the material safety data sheet.
Page 56 / 111
To Next Page
Loading...
Need help?
General
