Refitting
Note
Refitting is required only for robots with protection type Clean Room, with food
grade lubrication and with protection type Hygienic.
DescriptionAction
Use ethanol on a lint free cloth.Before the parts are refitted, clean the joint
so that it is free from oil and grease.
1
Place the tooling pin in hot water.2
xx0900000122
Seal all refitted joints with sealing compound.3
xx0900000125
Use the tooling pin to even out the surface
of the sealing compound.
4
For robots with protection type Clean
Room
For robots with protection type Clean Room
For robots with food grade lubrication
5
For robots with food grade lubrication
Wait 10 minutes.
Sikaflex 521FC skin dry time (10 minutes).
For robots with protection type Hygienic
For robots with protection type Hygienic
Wait 40 minutes.
Trans Clear skin dry time (40 minutes).
3HAC036639-001Use Touch up paint Clean Room/Hygienic,
white to paint any damaged surfaces.
Note
Always read the instruction in the product
data sheet in the paint repair kit for Clean
Room/Hygienic.
6
Continues on next page
Product manual - IRB 1200 159
3HAC046983-001 Revision: S
© Copyright 2014 - 2021 ABB. All rights reserved.
4 Repair
4.2.1 Cut the paint or surface on the robot before replacing parts
Continued
To Next Page
Loading...
