TERM INOLOGY GEN ERA L
1TNC9 2825 0M0201 2
1.3 Terminology
List of the terms, acronyms, abbreviations, and definitions that the document uses.
An intelligent motor controller for 3-phase AC in-
duction motors combining the two classical func-
tions of motor protection and motor manage-
ment in a single device plus offering diagnostic
and fieldbus communication
A factory-built assembly built to conform with IEC
61439-1
The digital solution based on low-voltage switch-
gear
ABB Ability™ Condition Monitoring for electrical
systems
Configuration and parameterization tool for ABB
LVS Digital smart devices including FC610
Fieldbus communication protocol based on serial
communication layer
Fieldbus communication protocol based on Ether-
net
Integrated clock function in devices used to gen-
erate time and date information if a remote clock
system is not present
A consequence of an alarm activated or an exter-
nal trip command from another device to stop the
motor or trip the circuit breaker.
Alarm is defined as status transition from any
state to abnormal state. Status transition to ab-
normal state can be data crossing over the pre-de-
fined alarm limit.
An event is a status transition from one state to
another. It can be defined as alarm, if the state is
defined as abnormal or as warning as a pre-alarm
state.
To Next Page
Loading...
