5.2.11 Replacing the power supply
Location
The illustration shows the location of the power supply in the controller.
xx2400000029
WARNING
Do not touch the power supply when the DC OK LED is on.
There is residual voltage in the power supply even if the main switch is in the
OFF position.
Required spare parts
Note
The spare part numbers that are listed in the table can be out of date. See the
latest spare parts of the OmniCore C30 Type A via myABB Business Portal,
www.abb.com/myABB.
NoteArticle numberSpare part
DSQC30353HAC071301-001Power supply
3HAB7983-1End clamp
Continues on next page
Product manual - OmniCore C30 Type A 293
3HAC089064-001 Revision: A
© Copyright 2024 ABB. All rights reserved.
5 Repair
5.2.11 Replacing the power supply
To Next Page
