55
FEM630 | ELECTROMAGNETIC FLOWMETER | OI/FEM630-EN REV. A
...7 Commissioning
Factory settings
The device can be factory parameterized to customer
specifications upon request. If no customer information is
available, the device is delivered with factory settings.
Switching on the power supply
• Switch on the power supply.
The LCD display shows the following display during the
startup process:
The process display is displayed after the startup process.
Easy Setup
Settings for the most common parameters are summarized in
the ‘Easy Setup’ menu. This menu provides the fastest way to
configure the device.
The following section describes parameterization via the
‘Easy Setup’ menu function.
1 Switch to the configuration level with .
2 Use / to select ‘Standard’.
3 Confirm the selection with .
4 Use to confirm the password. A password is not
available as factory default; you can continue without
entering a password.
Parameter Factory setting
Q
max
DN (see Table Measuring range table on
Sensor Tag
None
None
Unit Volumeflow Qv
ugal/min (US galon/minute)
Unit Vol. Totalizer
ugal (US gallon)
Pulses per Unit
Pulse Width
Damping
Impulses for Forward & Reverse
Flow Direction
Current output
Curr.Out at Alarm
Off
Low Flow Cut Off
EPD Alarm
Off
Enter Password
**********
Next
Access Level
Read Only
Back Select
Standard
System Startup
Processing
Q
0.00
0000.00
0000.00
ugal/s
ft³
ft³
To Next Page
Loading...
