ABB ProcessMaster FEP610 - Parameter Overview

44 OI/FEP610/FEH610-EN Rev. B | ProcessMaster FEP610, HygienicMaster FEH610
7.4 Parameter overview
NOTE
This overview of parameters shows all the menus and parameters available on the device. Depending on the version and
configuration of the device, not all of the menus and parameters may be visible in it.
Easy Setup Language
Unit Volumeflow Qv
Qv Max 1
Unit Vol. Totalizer
Pulses per Unit
Pulse Width
Damping
Dig.Out 41 / 42 Mode
Curr.Out at Alarm
Low Alarm
High Alarm
System Zero
Device Info ...Sensor QmaxDN Type
Meter Size
...Transmitter Qm Max DN
Qv Max DN
Mains Frequency
Exitation Freq
Coil Current Regul.
Set Point Curr.
DC feedback reg.
Sensor ID
Sensor Serial No.
Sensor Run Hours
...Se Calibration Se Zero
Se Span
First Cal. Date
Last Cal. Date
Cal. Cert. No.
First Cal. Location
Last Cal. Location