Figure 1 Hazardous Voltage Nameplate
1. SAFETY NOTICES
Install the R-MAG
®
breaker within the design limitations as described on its nameplate and in
these instructions.
Follow your company’s safety procedures and all applicable laws, regulations and standards
whenever the equipment is being installed, operated, maintained and/or repaired.
WARNING:
FOLLOW THE INSTRUCTIONS IN THIS MANUAL AS WRITTEN. ANY FAILURE TO
DO SO MAY RESULT IN DEATH OR SERIOUS BODILY INJURY
This breaker should not be used as the sole means of isolating a high voltage circuit. For the
safety of personnel performing maintenance operations on the breaker or connecting equip-
ment, all components should be electrically disconnected by means of a visible break and
should be securely grounded prior to working in the high voltage or low voltage compartment.
This product is intended to be operated and maintained by qualified persons, thoroughly trained
and knowledgeable of the hazards involved. This publication is written only for such qualified
persons and is not intended to be a substitute for adequate training and experience in the safety
procedures for this device.
WARNING
Detailed descriptions of standard repair procedures, safety principles and service operations are
not included. It is important to note this document contains some warnings and cautions against
some specific service methods that could cause personal injury to service personnel, damage
equipment, or render it unsafe. These warnings do not cover all conceivable ways in which serv-
ice, whether or not recommended by ABB, might be performed or the possible hazardous
consequences of each conceivable way, nor could ABB investigate all such ways. Anyone using
service procedures or tools, whether or not recommended by ABB, must satisfy himself
To Next Page
Loading...
