ABB R-MAG 38kV 1250/2000A - Apx Figure 4 Standard Actuator Circuit Board and DIP Switch Settings; Default Jumper and Dip Switch Settings

43
9. DEFAULT JUMPER AND DIP SWITCH SETTINGS
Unless specified by the customer, the Low Energy and Under Voltage trip functions are
disabled. Input three is set for Auxiliary trip mode as opposed to the Protection Relay trip mode.
The Protection Relay mode has a lower switching threshold (7 VDC). See section BINARY
INPUTS for the switch and jumper locations. The following represents the functional jumper and
dip switch settings which are the shipped configuration.
Apx Figure 4 Standard Actuator Circuit Board and DIP Switch Settings