ABB RED615 - Setting System Time and Time Synchronization

1.
Select Main Menu/Configuration/HMI/Default view and press .
2.
Change the default view with
or .
3.
Press to confirm the selection.
8.5.2.5 Setting system time and time synchronization
1.
Select Main Menu/Configuration/Time/System time and press .
2.
Select the parameter with or .
3.
Press , change the value with or and press again.
4. Repeat steps 2 and 3 to set the rest of the system time parameters.
5. Select Main Menu/Configuration/Time/Synchronization/Synch source and
press .
6. Set the time synchronization source to SNTP, Modbus, Line
differential or IRIG-B with or .
7.
Press
to confirm the selection.
If SNTP is used, the SNTP server's IP address is set in Main Menu/
Configuration/Time/Synchronization/IP SNTP Primary and Main Menu/
Configuration/Time/Synchronization/IP SNTP Secondary.
Setting daylight saving time
The IED can be set to determine the correct date for the DST shift every year. The
UTC time is used to set the DST.
1. Set the DST on day and DST off day parameters to define on which week day
the time shift occurs.
2. Set the DST on date and DST off date parameters to define on which month and
week the time shift occurs.
The DST on/off date must precede the selected DST on/off day and be within
the same week as the DST shift.
Table 19: DST change on Sunday
Day of the DST shift
DST on/off date
First Sunday of the month 1
Second Sunday of the month 8
Third Sunday of the month 15
Fourth Sunday of the month 22
Last Sunday, if the month has 30 days 24
Last Sunday, if the month has 31 days 25
For example, if the DST is observed from the last Sunday in March to the last
Sunday in October and the time shift occurs at 01:00 UTC, the setting parameters
are:
Section 8 1MRS756499 A
Commissioning
94 RED615
Operation Manual