ABB RED615 - Activating Leds

Only values within the selected setting group can be changed.
7.
Press or to change the value and to confirm the selection.
A070922 V3 EN
Figure 59: Editing setting group value
The active setting group is indicated with an asterisk * .
6.4.6 Activating LEDs
1.
Select Main Menu/Configuration/Alarm LEDs and press .
2.
Select an Alarm LED with or .
3.
Press to confirm the selection and to change the Alarm LED mode.
4.
Press or to change the value and to confirm the selection.
For more information, see PCM600 documentation.
Section 6 1MRS756499 A
Operating procedures
76 RED615
Operation Manual