ABB REG670 2.0 IEC - Page 14

Check the normal voltage regulation function...................... 215
Check the undervoltage block function................................ 215
Check the upper and lower busbar voltage limit.................. 216
Check the overcurrent block function................................... 216
Single transformer................................................................ 217
Parallel voltage regulation.................................................... 218
Completing the test.............................................................. 222
Single command, 16 signals SINGLECMD............................... 222
Interlocking................................................................................ 222
Logic............................................................................................... 223
Tripping logic, common 3-phase output SMPPTRC .................223
Three-phase operating mode............................................... 223
1ph/3ph operating mode...................................................... 223
1ph/2ph/3ph operating mode............................................... 224
Circuit breaker lockout..........................................................226
Completing the test.............................................................. 226
Integrator TIGAPC.....................................................................226
Completing the test.............................................................. 226
Monitoring.......................................................................................227
Gas medium supervision SSIMG.............................................. 227
Testing the liquid medium supervision for alarm and lock
out conditions....................................................................... 227
Completing the test.............................................................. 227
Liquid medium supervision SSIML............................................ 227
Testing the liquid medium supervision for alarm and lock
out conditions....................................................................... 228
Completing the test.............................................................. 228
Breaker monitoring SSCBR.......................................................228
Verifying the settings............................................................ 229
Completing the test.............................................................. 230
Event function EVENT...............................................................231
Limit counter L4UFCNT.............................................................231
Completing the test.............................................................. 231
Metering..........................................................................................231
Pulse-counter logic PCFCNT.................................................... 231
Function for energy calculation and demand handling
ETPMMTR.................................................................................231
Verifying the settings............................................................ 232
Completing the test.............................................................. 233
Station communication................................................................... 233
Multiple command and transmit MULTICMDRCV /
MULTICMDSND........................................................................233
Remote communication..................................................................233
Binary signal transfer BinSignReceive, BinSignTransm............233
Table of contents
8 Generator protection REG670 2.0 IEC
Commissioning manual