• In the short cut menu, right click and select Generate log.
• Click the Generate log button.
Besides generating a report you can also generate a log file with the same
information as for the report. Open and see the details of the file in Notepad or
MS Excel.
After a successful generation of the log, the system confirms with a message
along with the path of the log file.
6.8 Editing features in graph
You can do the following operations on the graph during calibration, commissioning
and monitoring:
• Zoom in
• Zoom out
• Cancel zoom
• Enable X-zooming
• Enable Y-zooming
1. Zoom in one of the following ways:
• Right click a graph and select Zoom in or Zoom out in the shortcut menu.
GUID-3F080E48-8B77-48A0-8283-89511E1AE50B V1 EN
Figure 17: Zooming via the shortcut menu
• Use the mouse to zoom in and select a part of the graph area.
1MRK502053-UEN B Section 6
Calibrating injection based sensitive rotor earth fault protection
Generator protection REG670 2.0 IEC 67
Commissioning manual
To Next Page
Loading...
