ABB REG670 2.0 IEC - Default Chapter; Table of Contents

Table of contents
Section 1 Introduction.....................................................................11
This manual...................................................................................... 11
Intended audience............................................................................ 11
Product documentation.....................................................................12
Product documentation set..........................................................12
Dokumentenänderungsverzeichnis............................................. 13
Related documents......................................................................14
Document symbols and conventions................................................14
Symbols.......................................................................................14
Document conventions................................................................15
IEC 61850 edition 1 / edition 2 mapping......................................16
Section 2 Safety information.......................................................... 25
Symbols on the product....................................................................25
Warnings.......................................................................................... 25
Caution signs....................................................................................27
Note signs.........................................................................................28
Section 3 Available functions......................................................... 29
Main protection functions..................................................................29
Back-up protection functions............................................................ 30
Control and monitoring functions......................................................31
Communication.................................................................................35
Basic IED functions.......................................................................... 37
Section 4 Starting up......................................................................39
Factory and site acceptance testing................................................. 39
Commissioning checklist.................................................................. 39
Checking the power supply.............................................................. 40
Energizing the IED............................................................................40
Checking the IED operation.........................................................40
IED start-up sequence.................................................................41
Energizing REX060.......................................................................... 41
REX060 start up sequence..........................................................41
Setting up communication between PCM600 and the IED...............41
Writing an application configuration to the IED.................................47
Checking CT circuits.........................................................................48
Checking VT circuits.........................................................................49
Using the RTXP test switch.............................................................. 49
Checking the binary input/output circuits..........................................50
Table of contents
Generator protection REG670 2.0 IEC 1
Commissioning manual