ABB REG670 2.0 IEC - Page 38

IEC 61850 ANSI Function description Generator
REG670
REG670 (A20) REG670 (B30)
REG670 (C30)
LOCREM Handling of LRswitch positions 1+5/APC30 1+5/
APC3
0
1+5/
APC3
0
1+5/
APC3
0
LOCREMCTRL LHMI control of PSTO 1+5/APC30 1+5/
APC3
0
1+5/
APC3
0
1+5/
APC3
0
TCMYLTC 84 Tap changer control and supervision, 6
binary inputs
0-4 1-A31 2-A33 2
TCLYLTC 84 Tap changer control and supervision, 32
binary inputs
0-4
SLGAPC Logic rotating switch for function selection
and LHMI presentation
15 15 15 15
VSGAPC Selector mini switch 20 20 20 20
DPGAPC Generic communication function for
Double Point indication
16 16 16 16
SPC8GAPC Single point generic control 8 signals 5 5 5 5
AUTOBITS AutomationBits, command function for
DNP3.0
3 3 3 3
SINGLECMD Single command, 16 signals 4 4 4 4
I103CMD Function commands for IEC 60870-5-103 1 1 1 1
I103GENCMD Function commands generic for IEC
60870-5-103
50 50 50 50
I103POSCMD IED commands with position and select for
IEC 60870-5-103
50 50 50 50
I103IEDCMD IED commands for IEC 60870-5-103 1 1 1 1
I103USRCMD Function commands user defined for IEC
60870-5-103
1 1 1 1
Secondary system supervision
CCSSPVC 87 Current circuit supervision 0-5 4 5 5
FUFSPVC Fuse failure supervision 0-3 2 3 3
VDSPVC 60 Fuse failure supervision based on voltage
difference
0-3 1-G03 1-G03 1-G03
Logic
SMPPTRC 94 Tripping logic 1-6 6 6 6
TMAGAPC Trip matrix logic 12 12 12 12
ALMCALH Logic for group alarm 5 5 5 5
WRNCALH Logic for group warning 5 5 5 5
INDCALH Logic for group indication 5 5 5 5
Table continues on next page
Section 3 1MRK502053-UEN B
Available functions
32 Generator protection REG670 2.0 IEC
Commissioning manual