ABB REG670 2.0 IEC - Page 42

IEC 61850 ANSI Function description Generator
REG670
REG670 (A20) REG670 (B30)
REG670 (C30)
MULTICMDRCV,
MULTICMDSND
Multiple command and transmit 60/10 60/10 60/10 60/10
FRONT, LANABI,
LANAB, LANCDI,
LANCD
Ethernet configuration of links 1 1 1 1
GATEWAY Ethernet configuration of link
one
1 1 1 1
OPTICAL103 IEC 60870-5-103 Optical serial
communication
1 1 1 1
RS485103 IEC 60870-5-103 serial
communication for RS485
1 1 1 1
AGSAL Generic security application
component
1 1 1 1
LD0LLN0 IEC 61850 LD0 LLN0 1 1 1 1
SYSLLN0 IEC 61850 SYS LLN0 1 1 1 1
LPHD Physical device information 1 1 1 1
PCMACCS IED Configuration Protocol 1 1 1 1
SECALARM Component for mapping
security events on protocols
such as DNP3 and IEC103
1
1 1 1
FSTACCS Field service tool access via
SPA protocol over ethernet
communication
1
1 1 1
ACTIVLOG Activity logging parameters 1 1 1 1
ALTRK Service Tracking 1 1 1 1
SINGLELCCH Single ethernet port link status 1 1 1 1
PRPSTATUS Dual ethernet port link status 1 1 1 1
PRP IEC 62439-3 parallel
redundancy protocol (only in
F00)
0-1
1-P03 1-P03 1-P03
Remote communication
Binary signal transfer receive/
transmit
6/36 6/36 6/36 6/36
Transmission of analog data
from LDCM
1 1 1 1
Receive binary status from
remote LDCM
6/3/3 6/3/3 6/3/3 6/3/3
Section 3 1MRK502053-UEN B
Available functions
36 Generator protection REG670 2.0 IEC
Commissioning manual