ABB REL670 - Side-By-Side Rack Mounting Details

26
Mounting methods and details Chapter 5
Installing the IED
3.5.1 Side-by-side rack mounting details
Figure 13: Side-by-side rack mounting details.
3.5.2 Mounting procedure for side-by-side rack mounting
Procedure
1. Place the two IEDs next to each other on a flat surface.
2. Fasten a side-by-side mounting plate (PosNo 1).
Use four of the delivered screws.
3. Carefully turn the two IEDs up-side down.
4. Fasten the second side-by-side mounting plate.
Use the remaining four screws.
5. Carefully fasten the mounting angles to the sides of the
IED (PosNo 4).
Use the screws available in the mounting kit.
6. Place the IED assembly in the rack.
7. Fasten the mounting angles with appropriate screws.
PosNo Description
1 Two mounting plates
2 Eight screws
3 Eight fastening screws
4 Two mounting angles
xx04000456.vsd
3
4
1
2