ABB REL670 - Testing IED Functions and Performance; IED Test Modes and Overview

67
Entering settings through the local HMI Chapter 10
Configuring the IED and changing
settings
2 Entering settings through the local HMI
Each of the included functions in the IED has to be set and this can be performed through the
local HMI. The user must browse to the desired function and enter the appropriate value. The
parameters for each function can be found in the local HMI.
The Operators Manual (OM) is structured in a similar way to the LHMI and provides a detailed
guide to the use of the local HMI including paths in the menu structure and brief explanations
of most settings and measurements. See the Technical reference manual for a complete list of
setting parameters for each function. Some of the included functions may not be used. In this
case the user can set the parameter “Operation” to “Off” to disable the function.