20
Mounting methods and details Chapter 5
Installing the IED
3 Mounting methods and details
3.1 Mounting the IED
Most of the REx670 IEDs can be rack, flush or wall mounted with the use of different mounting
kits. An additional box of type RHGS can be mounted to one side of a 1/2 or 3/4 IED.
A suitable mounting kit is available. Mounting kits contain all parts needed including screws and
assembly instructions. The following mounting kits are available:
• Flush mounting kit
• 19” Panel (rack) mounting kit
• Wall mounting kit
• Side-by-side rack mounting kit
• Side-by-side flush mounting kit
3.2 Flush mounting
All IED sizes, 1/2, 3/4 and 1/1 of 19” and RHGS 6 6U 1/4x19”, cases, can be flush mounted.
Only a single case can be mounted in each cut-out on the cubicle panel, for class IP54 ingression
protection.
Note!
Flush mounting cannot be used for side-by-side mounted IEDs when IP54 class must be fulfilled.
Only IP20 class can be obtained when mounting two cases side-by-side in one (1) cut-out.
Note!
To obtain IP54 class protection, an additional factory mounted sealing must be ordered when
ordering the IED.
To Next Page
Loading...
