28
Mounting methods and details Chapter 5
Installing the IED
2. Fasten a side-by-side mounting plate (PosNo 1)
Use four of the delivered screws (PosNo 2).
3. Carefully turn the two IEDs up-side down
4. Fasten the second side-by-side mounting plate
Use the remaining four screws.
5. Carefully fasten the mounting angles to the sides of the
IED (PosNo 4)
Use the fixing screws available in the mounting kit (PosNo 3).
6. Make a panel cut-out
See the section about side-by-side flush mounting dimensions.
7. Insert the IED into the cut-out
8. Fasten the mounting angles with appropriate screws
To Next Page
Loading...
