ABB Relion 620 Series - Using the Web HMI

2.4.7 Generic functions
2.4.7.1 LD0.SPCGGIO1 Multipurpose binary outputs (1)
The binary outputs can be configured either as pulse- or persistent-type outputs. Pulse-
type outputs are triggered with the write value "1". Persistent-type outputs can be
written with both values "1" and "0" values. The setting mode "toggled" for local
operation corresponds to "persistent" for remote operation.
Table 135: LD0.SPCGGIO1 Multipurpose binary outputs (1)
IEC 61850 name SA name Description Type
LD0.SPCGGIO1
.SPCS01.ctlVal - Output 1 control On/Off
.SPCS02.ctlVal - Output 2 control On/Off
.SPCS03.ctlVal - Output 3 control On/Off
.SPCS04.ctlVal - Output 4 control On/Off
.SPCS05.ctlVal - Output 5 control On/Off
.SPCS06.ctlVal - Output 6 control On/Off
.SPCS07.ctlVal - Output 7 control On/Off
.SPCS08.ctlVal - Output 8 control On/Off
.SPCS09.ctlVal - Output 9 control On/Off
.SPCS10.ctlVal - Output 10 control On/Off
.SPCS11.ctlVal - Output 11 control On/Off
.SPCS12.ctlVal - Output 12 control On/Off
.SPCS13.ctlVal - Output 13 control On/Off
.SPCS14.ctlVal - Output 14 control On/Off
.SPCS15.ctlVal - Output 15 control On/Off
.SPCS16.ctlVal - Output 16 control On/Off
2.4.7.2 LD0.SPCGGIO2 Multipurpose binary outputs (2)
The binary outputs can be configured either as pulse- or persistent-type outputs. Pulse-
type outputs are triggered with the write value "1". Persistent-type outputs can be
written with both values "1" and "0". The setting mode "toggled" for local
operation corresponds to "persistent" for remote operation.
Table 136: LD0.SPCGGIO2 Multipurpose binary outputs (2)
IEC 61850 name
SA name Description Type
LD0.SPCGGIO2
.SPCS01.ctlVal - Output 1 control On/Off
.SPCS02.ctlVal - Output 2 control On/Off
.SPCS03.ctlVal - Output 3 control On/Off
Table continues on next page
1MRS757660 A Section 2
DNP3 data mappings
RET620 57
Point List Manual