ABB Relion 670 series - Mounting Procedure for Flush Mounting

• 1/2 x 19”
• 3/4 x 19”
• 1/1 x 19”
• 1/4 x 19” (RHGS6 6U)
Only a single case can be mounted in each cut-out on the cubicle panel, for class
IP54 protection. The screws from the IED shall be used to fasten the fasteners to
the IED.
Flush mounting cannot be used for side-by-side mounted IEDs
when IP54 class must be fulfilled. Only IP20 class can be obtained
when mounting two cases side-by-side in one (1) cut-out.
To obtain IP54 class protection, an additional factory mounted
sealing must be ordered when ordering the IED.
5.3.1.2 Mounting procedure for flush mounting
M11942-2 v5
1
5
6
3
IEC16 000080=1=en .vsd
2
4
IEC16000080 V1 EN-US
Figure 3: Flush mounting details.
1MRK 514 026-UEN B Section 5
Mounting
670 series 2.2 IEC 23
Installation manual