ABB Relion 670 series - Mounting Procedure for Side-By-Side Flush Mounting; Mounting the Injection Unit REX060 (REG670 Only)

5.3.5.2 Mounting procedure for side-by-side flush mounting
M12730-6 v4
1
2
3
4
IEC06000181-2-en.vsd
IEC06000181 V2 EN-US
Figure 9: Side-by-side flush mounting details (RHGS6 side-by-side with 1/2 x
19” IED).
The required torque for the screws is 3.5 Nm.
PosNo Description Quantity Type
1 Mounting plate 2 -
2, 3 Screw, washer 16 M4x6
4 Mounting angle 2 -
5.3.6 Mounting the injection unit REX060 (REG670 only)
GUID-264732AC-6C84-44E6-9F86-2065AD0B7D5B v3
The injection unit REX060 case size is 6U, 1/2 x 19”. REX060 can be rack, wall or
flush mounted in the same way as the IED. For guidance, see instructions for rack
mounting, wall mounting or flush mounting the IED in this manual.
REX060 shall be mounted close to the IED. It is recommended that they are
mounted in the same cubicle.
1MRK 514 026-UEN B Section 5
Mounting
670 series 2.2 IEC 31
Installation manual