80 mm
1
3
2
IEC06000135-2-en.vsd
IEC06000135 V3 EN-US
Figure 6: How to reach the connectors on the rear side of the IED.
PosNo Description Type
1 Screw M4x10
2 Screw M5x8
3 Rear protection cover (Ordered separately)
5.3.4 Side-by-side 19” rack mounting
IP10323-1 v1
5.3.4.1 Overview
M11974-3 v3
IED case size 1/2 x 19” or 3/4 x 19” and RHGS cases can be mounted side-by-side
up to a maximum size of 19”. For side-by-side rack mounting, the side-by-side
mounting kit together with the 19” rack panel mounting kit must be used. The
mounting kit has to be ordered separately.
Use only the screws included in the mounting kit when mounting
the plates and the angles on the IED. Screws with wrong dimension
may damage the PCBs inside the IED.
Section 5 1MRK 514 026-UEN B
Mounting
28 670 series 2.2 IEC
Installation manual
To Next Page
Loading...
