ABB Relion 670 series - Mounting Procedure for Side-By-Side Rack Mounting; IED Mounted with a RHGS6 Case

5.3.4.2 Mounting procedure for side-by-side rack mounting
M11955-2 v3
IEC040004563enOriginal.vsdx
1
2
3
4
3
IEC04000456 V3 EN-US
Figure 7: Side-by-side rack mounting details.
The required torque for the screws is 3.5 Nm.
PosNo Description Quantity Type
1 Mounting plate 2 -
2, 3 Screw 16 M4x6
4 Mounting angle 2 -
5 Washer 16 M4x6
5.3.4.3 IED mounted with a RHGS6 case
M11953-3 v4
A 1/2 x 19” or 3/4 x 19” size IED can be mounted with a RHGS case (6 or 12
depending on IED size). The RHGS case can be used for mounting a test switch of
type RTXP 24. It also has enough space for a terminal base of RX 2 type for
mounting of, for example, a DC-switch or two auxiliary relays.
1MRK 514 026-UEN B Section 5
Mounting
670 series 2.2 IEC 29
Installation manual