Select and execute set point command
C_SE ACTTERM used
No additional definition
Short-pulse duration (duration determined by a system parameter in the outstation)
Long-pulse duration (duration determined by a system parameter in the outstation)
Persistent output
Transmission of integrated totals
(Station- or object-specific parameter, mark with an “X“ if the function is only used
in the standard direction, “R“ if only used in the reverse direction, and “B“ if used in
both directions.)
Mode A: Local freeze with spontaneous transmission
Mode B: Local freeze with counter interrogation
Mode C: Freeze and transmit by counter-interrogation commands
Mode D: Freeze by counter-interrogation command, frozen values reported
Counter read
Counter freeze without reset
Counter reset
General request counter
Request counter group 1
Request counter group 2
Request counter group 3
Request counter group 4
Parameter loading
(Object-specific parameter, mark with an “X“ if the function is only used in the
standard direction, “R“ if only used in the reverse direction, and “B“ if used in both
directions.)
Threshold value
Smoothing factor
Table continues on the next page
2NGA001859 A IEC 60870-5-104 interoperability
REX615
IEC 60870-5-104 Communication Protocol Manual
45
To Next Page
Loading...
