ABB SACE Emax 2 - Introduction; Contents

ABB | SACE Emax 2
4 | © 2019 ABB | 1SDH001316R1002 - ECN000086501 - Rev. A Introduction | 1 - Contents
Introduction
1 - Contents
Overview
This manual describes the characteristics of the Ekip Touch Trip units installed on SACE Emax 2 CBs, among
which:
1. general overview:
2. operating conditions
3. consultation of menus for changing parameters and displaying measurements
4. overview of protections, measurements, parameters and main accessories
5. management operations: maintenance, troubleshooting
Integrated informations
A full description of Ekip Touch is available in document 1SDH001330R1002 (Emax 2 engineering manual)
available on the website ABB library.
recipients
This manual refers to two user profiles, as defined by standard IEC 60050:
• skilled person, in the electrical field (IEV 195-04-01): person with relevant education, training, knowledge
and experience to enable him or her to perceive risks and to avoid danger which electricity can create
• instructed person, in the electrical field (IEV 195-04-02): person adequately advised or supervised by
electrically skilled persons to enjable him or her to perceive risks and to avoid danger which electricity
can create
IMPORTANT: operations which can be performed by persons trained on the subject
of electricity are specifically indicated in this manual. All the remaining operations
described in this manual must be performed by skilled persons, in the field of
electricity.ABB declines all liability for damage to persons or property caused by
failure to comply with the instructions in this document.
Specifications and supporting
documents
To ensure that Ekip Touch is installed and configured correctly, please read the information in this manual and
in the technical documentation of the product, supplied with the circuit-breaker or available in the website
ABB liBRARy
Document Description
1SDH000999R0002
Installation, operation and maintenance instructions for Sace Emax E1.2 CBs
and Ekip Dip Trip units
1SDH001000R0002
Installation, operation and maintenance instructions for Sace Emax E2.2-
E4.2-E6.2 CBs and Ekip Dip Trip units
1SDH001330R1002
Manual for design engineers with full information about the trip units and
accessories for Emax 2
1SDH001140R0001 Communication System Interface for Emax 2 CBs
1SDC200023D0906 Sace Emax 2 CBs General catalog
1SDM000091R0001 Sace Emax 2 CBs Circuit diagrams
WARNING! carefully read the instructions for putting into service and maintenance
given in the installation manuals 1SDH000999R0002 (for E1.2) or 1SDH001000R0002
(for E2.2-E4.2-E6.2).
Design notes
The information in this manual was written in Italian and then translated into other languages to conform to
the laws and/or commercial requirements concerning the product.