ABB SACE Emax E4.2 - Aux 15 Q: External Additional Open;Closed Auxiliary Contacts

ABB | SACE Emax 2
232 | © 2013 ABB | 1SDH001000R0002 - L7804
Electrical accessories | 2 - Electrical signalling accessories
Aux 15Q: External additional
open/closed auxiliary contacts
The external additional Aux 15Q contacts signal the open/closed state of the circuit-breaker.
These are "switched" contacts and are available in two types:
• 15 standard contacts
• 15 digital signals (low power)
The following table provides information on the electrical characteristics:
Characteristics Standard Digital signals
Breaking
capacity
DC
24V - 0.1 A
125V 0.5A @ 0ms / 0.3A @ 10ms -
250V
0.3A @ 0ms / 0.15A @
10ms
-
AC
250V
3A cos φ 0,3 -
5A cos φ 0,7 -
5A cos φ 1 -
400V
3A cos φ 1 -
2A cos φ 0,7 -
1A cos φ 0,3 -
Minimum load 50mA @ 24V 1mA @ 5V
Aux 15Q external: Connections
Further information is available on page 156, or on the site http://www.abb.com/abblibrary/
DownloadCenter/, where the wiring diagram is available 1SDM000091R0001.
91
A4
Q/18
272 274
271
Q/17
262 264
261
Q/16
252 254
251
Q/15
242 244
241
Q/14
232 234
231
Q/13
222 224
221
Q/12
212 214
211
Q/11
202 204
201
Q/25
342 344
341
Q/24
332 334
331
Q/23
322 324
321
Q/22
312 314
311
Q/21
302 304
301
Q/20
292 294
291
Q/19
282 284
281
Diagram 91
Information on the assembly is available from the web site http://www.abb.com/abblibrary/
DownloadCenter/, in particular with the kit sheet 1SDH001000R0607.