ABB SACE Tmax XT5 - Page 35

ABB | SACE Tmax XT
Interface and menus | 4 - Menu33 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
Settings Menu
Menu Submenus Description and parameters Page
Circuit Breaker
Configuration Phase number selection 114
Hardware Trip Protection activation command 48
T Protection Protection activation command 48
Neutral Protection
(2)
Enable, Neutral threshold 48
Installation Installation of modules 34
Main Frequency - Grid frequency configuration 114
Phase Sequence - Phase sequence configuration 52
Modules
Local/Remote Parameter writing configuration 116
Local Bus Configuration of local bus presence 116
Modul x
(3)
Details in chapters of each module 116
BLE LV communication configuration 116
Functions Switch On LOCAL, Signalling RESET 116
Monitor time - Measuring range configuration 99
Test Bus - Test bus activation 116
Power Controller
(4)
Enable
(5)
Function enabling and parameters: see
details in dedicated chapter
122
- 122
Load Shedding
(4)
Enable
(5)
Function enabling and parameters: see
details in dedicated chapter
122
- 122
Network Analyzer
(6)
Enable
(5)
Function enabling and parameters: see
details in dedicated chapter
107
- 107
Datalogger
(6)
Enable
(5)
Function enabling and parameters: see
details in dedicated chapter
105
- 105
Dual Set
(6)
Enable
(5)
Function enabling and parameters: see
details in dedicated chapter
67
Default set 67
System
Date Configuration of unit date 116
Time Configuration of unit time 116
Language Configuration of menu language 116
New PIN PIN Configuration 116
View -
Representation parameters of menus
and measurements: see details in
dedicated chapter
116
Functions
YO Command
Function, Delay
76
YC Command 76
Maintenance Alarms Activation of maintenance signals 100
MLRIU
(7)
-
Motor protection parameters: see details
in dedicated chapter
67
(1)
with CB in 3P configuration
(2)
available with CB in 4P or 3P with neutral configuration
(3)
the menu populates with the list of accessory modules detected by the unit with Local Bus activated and in
the envisaged connection and supply conditions
(4)
available if the function has been installed in the Trip unit
(5)
additions are only made to the list of the specific submenu when the function is enabled (=On)
(6)
available if provided for by Trip unit model or if relative SW package has been activated
(7)
available with Ekip M Touch