ABB SACE Tmax XT7 - 5 - Changing Parameters and Commands

ABB | SACE Tmax XT
Ekip Touch - Interface and menus | 4 - Menu37 | © 2020 ABB | 1SDH001821A1002 - ECN000135670
Settings Menu
Menu Submenus Description and parameters Page
Bluetooth Low
Energy
Enable
(5)
Enabling and configuration of Bluetooth
Low Energy communication
127
-
Circuit Breaker
Configuration Phase number selection 126
Hardware Trip Protection activation command 52
T Protection Protection activation command 52
Neutral Protection
(2)
Enable, Neutral threshold 52
Ground Protection
(8)
External toroid configuration 128
Installation Installation of modules 38
Main Frequency - Grid frequency configuration 126
Phase Sequence - Phase sequence configuration 55
Modules
Local/Remote Parameter writing configuration 127
Local Bus Configuration of local bus presence 127
Modul x
(3)
Details in chapters of each module 127
Functions Switch On LOCAL, Signalling RESET 127
Monitor time - Measuring range configuration 111
Test Bus - Test bus activation 129
Network Analyzer
(6)
Enable
(5)
Function enabling and parameters: see
details in dedicated chapter
119
- 119
Datalogger
(6)
Enable
(5)
Function enabling and parameters: see
details in dedicated chapter
117
- 117
Dual Set
(6)
Enable
(5)
Function enabling and parameters: see
details in dedicated chapter
70
Default set 70
System
Date Configuration of unit date 129
Time Configuration of unit time 129
Language Configuration of menu language 129
New PIN PIN Configuration 129
View -
Representation parameters of menus
and measurements: see details in
dedicated chapter
129
Functions
YO Command
Function, Delay
84
YC Command 84
Maintenance Alarms Activation of maintenance signals 112
MLRIU
(7)
-
Motor protection parameters: see details
in dedicated chapter
70
(1)
with CB in 3P configuration
(2)
available with CB in 4P or 3P with neutral configuration
(3)
the menu populates with the list of accessory modules detected by the unit with Local Bus activated and in
the envisaged connection and supply conditions
(4)
available if the function has been installed in the Trip unit
(5)
additions are only made to the list of the specific submenu when the function is enabled (=On)
(6)
available if provided for by Trip unit model or if relative SW package has been activated
(7)
available with Ekip M Touch
(8)
available with LSIG versions