WBPEEUI240751C0 PR16 - 1
PR16
RLY-200 Setup
Purpose/Scope
This procedure gives the steps required to set up the RLY-200
block for proper operation.
NOTE: NC on the terminal label means not connected.
Parts
To o l s
• Small-tipped, flat-blade screwdriver.
Safety Considerations
Procedure
□
1. Install the relays in sockets XK17 through XK24
(Fig. PR16-1). The block can be populated with relays of differ-
ent ratings. They do not all have to be the same.
a. Verify the relay being installed is an approved relay
(refer to Section 11).
15 min.
Number Qty Description
1947684A32 1 - 8 120 VAC solid state relay
240 VAC solid state relay
1947685A31 24 VDC solid state relay
1947685A32 125 VDC solid state relay
1949438A1001 1 - 8 125 VDC relay fuse
1949438A3151 24 VDC r elay fuse
1949697A3151 120 VAC relay fuse
240 VAC relay fuse
CAUTION
1. Use only ABB Automation approved relays on the relay
assembly. Usi n g unapproved relays could improperly route
signals and damage equipment connected to t he relay and the
relay itself. CSA certification is voided when unapproved
relays are used.
C1
To Next Page
Loading...
