PR17 - 2 WBPEEUI240751C0
Procedure
To o l s
• IISAC01 Analog Control Station instruction.
Procedure
Figure PR17-2 shows the cabling required to connect an
IISAC01 station that supports current mode bypass operation.
Figure PR17-3 shows the cabling required to connect an
IISAC01 station that supports electric drive/pulse positioner
bypass operation.
NOTE: The CIO-110 block must be located either directly above or directly
below the CIO-100 block it is to connect to.
□
Make the necessary cable connections as shown in
Figure PR17-2 or PR17-3.
Table PR17-1. CIO- 100 t o CIO-110 Connector Relationship
Station CIO-100 CIO-110
1 P7 P1, P2
2 P8 P3, P4
Table PR17-2. CIO- 100 and IISAC 01 Analog Input Rela tionsh ip
Station
CIO-100 IISAC01
Connector Analog Input Analog Input
1 P7 CH1 AI1 AI1
CH2 AI2 AI2
2 P8 CH3 AI3 AI1
CH4 AI4 AI2
To Next Page
Loading...
