PR3 - 2 WBPEEUI240751C0
Procedure
much pressure. If the I/O module cannot be pushed in flush
with the base, then either it is not properly aligned or it is not
compatible with the particular base.
□
5. Tighten the captive front panel fastening screw. The fas-
tening screw actually threads into the mounting column and
not into the base. Do not overtighten.
Figure PR3-1. I/O Module Attachment
T00911B
ALIGNMENT
POSTS
FA S T E N IN G
SCREW
RETRACTABLE
HANDLE
To Next Page
Loading...
